Based in Edgewood, NM · serving the Albuquerque metro and the East Mountains
24-Hour Emergency Service · Free Estimates (505) 306-8285
Wright Flow Plumbing and Heating
Our Services

Water Heater Repair in Edgewood, NM

Water Heater Repair · Edgewood, NM

No hot water, a leak, or a heater that quit

Water heater repair starts with what the heater is doing. No hot water, not enough hot water, a puddle under the tank, or a rumble every time it heats. We work on gas and electric tank heaters and on tankless units, in houses, rentals and small commercial buildings. Call (505) 306-8285 and tell us what you are seeing.

Most repairs come down to a handful of parts. On a gas heater it is the pilot assembly, the thermocouple, the igniter or the gas valve. On an electric heater it is usually an element or a thermostat. If the tank itself has failed, water heater installation is the better answer.

What We Handle

  • No hot water and not enough hot water on gas and electric tanks
  • Pilot assemblies, thermocouples, igniters and gas control valves
  • Heating elements, thermostats and high limit resets on electric units
  • Leaks at fittings, flex connectors, drain valves and T and P valves
  • Sediment flushes and maintenance on tank water heaters
  • Tankless repairs, including ignition faults, error codes and descaling
  • Water that runs too hot, too cold, rusty or smelly
  • Emergency calls day and night when a heater quits in a cold snap

Free Water Heater Repair Quote

Tell us about the job. We will get right back to you.

No hot water on a gas or electric water heater

A gas water heater with no hot water usually has a burner that is not lighting. We check the pilot or the igniter first, then the thermocouple. Next comes the gas control valve and the gas supply to the unit.

An electric heater has two elements and two thermostats in most tanks. When the top element fails you get no hot water at all. When the bottom element fails you get a little hot water, then cold. We check the breaker and the high limit reset button before we open the unit.

Lukewarm water that never gets hot can also start at a fixture. A crossover at a single handle faucet sends cold water into the hot line. That is a faucet and valve repair. We test the heater and the nearest fixtures so the repair matches the problem.

Why is my water heater leaking?

Where the water comes from decides whether this is a repair. Leaks at the cold and hot fittings, the drain valve or the T and P valve are usually repairable. We dry the tank, run it, and find the source before we price the work.

A leak from the bottom of the tank itself is a different answer. That is rust through the tank wall, and a rusted tank gets replaced. Many tanks carry a manufacturer warranty on the shell. Check the label before you buy a new unit.

A heater dumping water into the room is an emergency. We take those calls day and night. Our emergency plumbing page covers what to shut off first.

Hard water, sediment and altitude in the Albuquerque area

Albuquerque's water authority says hardness runs from moderately hard to hard, depending on the source and the blend. It also tells customers that white bits clogging a faucet can be scale from the water heater. A thermostat set too high makes that scaling worse. Out in the East Mountains many homes run on well water, which brings its own minerals.

Sediment is why a tank rumbles, pops or takes longer to heat. The layer on the bottom traps heat under it and wastes fuel. Flushing the tank clears it. Scale builds up inside tankless water heaters the same way, and those need a descale.

Altitude changes how a gas heater burns. Above about 2,000 feet, a unit built for sea level needs less fuel for a clean flame. Edgewood sits near 6,700 feet, and Albuquerque runs about 5,300 feet in the valley. A yellow flame or soot on the burner plate means the mix is off.

Rust and corrosion spreading around the base of a leaking water heater Gloved hands turning a wrench on the gas line fitting at a water heater

Ready to get started?

Free estimates and site visits across Albuquerque, Rio Rancho, Corrales, the East Mountains and about 70 miles around Edgewood.

(505) 306-8285
How We Work

How a Job With Wright Flow Plumbing and Heating Runs

From the first call to the final test, here is how it goes.

1

You call

Call (505) 306-8285 and tell us what is happening and where. We ask a few questions so we bring the right parts.

2

We get you on the schedule

Emergencies go first. Everything else gets a day and a window that works for you.

3

We look at the job

We find what is actually wrong and explain it in plain words. Then the estimate goes in writing before any work starts.

4

We do the work

The repair or the install, with the parts it needs. Where a permit or an inspection is required, we handle that paperwork with you.

5

We test it and clean up

We run the water or fire the unit and check it. Then we clean up and tell you how to keep it working.

FAQ

Water Heater Repair Questions, Answered

Common questions about water heater repair across Albuquerque, Rio Rancho, Corrales, the East Mountains and about 70 miles around Edgewood. If yours is not here, call and ask.

Call (505) 306-8285

Can you repair a tankless water heater?
Yes. Tankless units fail on ignition, flow sensors, flame rods and error codes. Most of that is a parts and cleaning job. Hard water is the other common cause, and a descale brings the flow back.
My water heater makes a popping or rumbling noise. Is that bad?
That is sediment. Water trapped under the layer on the tank bottom boils and pops. The tank still runs, but the bottom gets hotter than it should and wears faster. A flush usually quiets it down.
Water drips from the pipe on the side of my hot water heater. What is that?
That pipe is the T and P discharge, and it dumps when temperature or pressure climbs too high. Sometimes the thermostat is set too high. Sometimes the house is on a closed system and the pressure has nowhere to go. Never cap that pipe; call us and we will find the cause.
Should I repair my water heater or replace it?
It depends on where it leaks and which part failed. A pilot assembly, an element, a thermostat or a valve is a repair. Rust through the tank wall, or an old tank with a failed part, calls for a new heater. We tell you what we found and price it both ways before you decide.
How much does water heater repair cost?
It depends on the part, the fuel type, and how the heater is plumbed and vented. A thermocouple is a small job, and a gas control valve is a bigger one. A tight closet or an attic install adds time. The estimate is free and in writing, so call (505) 306-8285.
The pilot light will not stay lit. What is wrong?
Most of the time it is the thermocouple, which tells the gas valve that the flame is there. A dirty pilot orifice, a draft down the vent, or a failing gas valve cause the same thing. We test those parts rather than swap them one at a time.
More From Wright Flow Plumbing and Heating

Work That Pairs With Water Heater Repair

Newly installed tank water heater with copper risers and an expansion tank

Water Heater Installation

We install and replace tank water heaters, gas and electric, for homes and small commercial buildings. The old unit goes with us when we leave.

Learn More
Wall-mounted gas tankless water heater with copper piping in a garage

Tankless Water Heaters

We install and replace tankless water heaters in houses, rentals and small commercial buildings. Sizing, the gas line, the vent and the descaling schedule are part of the job.

Learn More
Copper water pipe split open by freezing

Emergency Plumbing

Burst pipe, sewer backup or no hot water in the cold. We take emergency plumbing calls 24 hours a day across the Albuquerque metro and the East Mountains.

Learn More
Why Choose Wright Flow Plumbing and Heating

Built for Plumbing and Heating in the Albuquerque Metro and the East Mountains

Plumbing and heating in one company

Drains, water heaters, gas lines and sewer work, plus boilers, radiant heat and mini splits. One call covers the water and the heat.

24 hour emergency service

Burst pipes, sewer backups and dead water heaters do not wait for Monday. Call any hour and we will get you scheduled as fast as we can.

Homes and businesses

Houses, manufactured homes, rentals and small commercial buildings. Landlords and property managers keep us on a maintenance schedule.

Based in Edgewood, working the metro

We run about 70 miles out from Edgewood, into Albuquerque, Rio Rancho, Corrales and down to Los Lunas. The East Mountains are home.

Guides and Resources

Water Heater Repair Guides

Free Estimates

Get In Touch With Wright Flow Plumbing and Heating

Tell us what is going on and where the house or building is, and we will come look at it. Call (505) 306-8285 or fill out the form and we will get back to you.

  • (505) 306-8285
  • Edgewood, NM · serving Albuquerque, Rio Rancho, Corrales, the East Mountains and about 70 miles around Edgewood
  • Free estimates · drains, water heaters, septic, sewer, gas, boilers and mini splits

Get a Free Quote

Tell us about the job. We will get right back to you.