Based in Edgewood, NM · serving the Albuquerque metro and the East Mountains
24-Hour Emergency Service · Free Estimates (505) 306-8285
Wright Flow Plumbing and Heating
Our Services

Boiler Repair and Installation in Edgewood, NM

Boilers and Radiant Heat · Edgewood, NM

Boiler service for radiant and baseboard heat

Boiler repair is a cold weather call. The heat quits, one zone stays cold, or you find water under the boiler. We work on residential boilers, hydronic baseboard heat and radiant floor heating. Call (505) 306-8285 and tell us what the system is doing.

Wright Flow Plumbing and Heating is based in Edgewood and works Albuquerque, Rio Rancho, Corrales and the East Mountains. Heating and plumbing sit under one company here, so the boiler and the pipe feeding it are the same call. We handle boiler service, repairs and full boiler replacement, along with the gas line installation a new unit needs. Residential and commercial both.

What We Handle

  • No heat calls on residential boilers
  • Pilot, ignition and burner control problems
  • Circulator pumps, zone valves and thermostats that stopped calling for heat
  • Expansion tanks, low pressure and relief valves that drip
  • Leaks at the boiler, the fittings and the piping around it
  • Air in the lines and baseboards that stay cold at one end
  • Radiant floor loops, manifolds and zone controls
  • Boiler replacement sized for the house and set up for our altitude

Free Boilers and Radiant Heat Quote

Tell us about the job. We will get right back to you.

Why is the boiler running but the house is still cold?

A boiler that fires without warming the house usually has a circulation problem. The pump may have failed, a zone valve may be stuck, or air may be trapped in the loop. Baseboards that run hot at one end and cold at the other point at air or a weak pump. We check the pump, the zone valves and the system pressure first.

No heat at all is a different list. The boiler may have lost pressure, tripped a safety, or failed to light. Low pressure often means the system is losing water somewhere, so we go find it. A dead thermostat or a bad control can also stop the call for heat.

Water on the floor is its own call. A relief valve that drips usually traces back to pressure or a tired expansion tank. A wet spot under the unit can be a fitting, a pump seal or the boiler body itself. Most heating repair here ends at one of those parts.

Boiler installation and replacement at East Mountains altitude

Gas appliance ratings are written for elevations up to 2,000 feet. Above that, the national fuel gas code derates the input about 4 percent for every 1,000 feet. Edgewood sits near 6,700 feet and the Albuquerque valley near 5,300 feet. Many units also need a high altitude orifice or kit from the maker.

So sizing starts with the house itself. Square footage, insulation, windows, the number of zones and the elevation all feed the number. Then we put the estimate in writing before any work starts.

A replacement is more than setting a new unit on the pad. Venting, the gas connection, the expansion tank, the pump and the piping at the boiler often change with it. Some homeowners move to a combination boiler that heats the house and makes the hot water. A separate tank is its own machine, and water heater repair covers those.

Radiant floor heating and baseboard heat in older homes

Plenty of homes around Albuquerque and the East Mountains heat with hot water instead of forced air. Some run baseboard along the walls. Others have radiant heat in loops buried in a concrete slab. Both sides need the same pump, zone valve and pressure work when they quit.

Houses built in the 1940s and 1950s often had copper or steel tubing poured straight into the slab. Those loops can leak where the concrete cracked or where the metal corroded. A slab leak shows up as pressure the system keeps losing and a warm stripe on a cold floor. When a loop is truly done, a ductless mini split can heat and cool that room instead.

Annual boiler service is worth booking before the first hard freeze. We check pressure, the expansion tank, the relief valve, the pump and the burner. A small problem found in October is a smaller problem than no heat in January.

Hydronic baseboard radiator running along the base of a wall Pressure gauge on a boiler line read close up

Ready to get started?

Free estimates and site visits across Albuquerque, Rio Rancho, Corrales, the East Mountains and about 70 miles around Edgewood.

(505) 306-8285
How We Work

How a Job With Wright Flow Plumbing and Heating Runs

From the first call to the final test, here is how it goes.

1

You call

Call (505) 306-8285 and tell us what is happening and where. We ask a few questions so we bring the right parts.

2

We get you on the schedule

Emergencies go first. Everything else gets a day and a window that works for you.

3

We look at the job

We find what is actually wrong and explain it in plain words. Then the estimate goes in writing before any work starts.

4

We do the work

The repair or the install, with the parts it needs. Where a permit or an inspection is required, we handle that paperwork with you.

5

We test it and clean up

We run the water or fire the unit and check it. Then we clean up and tell you how to keep it working.

FAQ

Boilers and Radiant Heat Questions, Answered

Common questions about boilers and radiant heat across Albuquerque, Rio Rancho, Corrales, the East Mountains and about 70 miles around Edgewood. If yours is not here, call and ask.

Call (505) 306-8285

Should I repair the boiler or replace it?
It depends on where the failure is. A pump, a zone valve, a thermostat or an ignition part is usually a repair. A cracked section or a leaking heat exchanger usually points at boiler replacement. When both are real options, we lay out both before you decide.
What does boiler repair cost?
The part drives most of it. A zone valve is one kind of job and a failed heat exchanger is another. Access counts too, since a boiler wedged in a closet takes longer than one sitting in a garage. We look at the system and give you a free estimate before any work starts.
Do you work on radiant floor heating?
Yes. We service radiant floor loops, manifolds, zone valves and the boiler feeding them. Slab loops in older houses get a closer look, because a leak under concrete changes the answer.
Do you come out to Albuquerque and Rio Rancho for boiler service?
Yes. We are a plumbing and heating contractor based in Edgewood, working about 70 miles around. That covers Albuquerque, Rio Rancho, Corrales, Bernalillo, Placitas, Los Lunas and the East Mountains. Boiler work travels the same radius as the rest of our plumbing and heating.
My heat went out at night. Can you come out?
Call (505) 306-8285 any hour, day or night. Our 24-hour emergency service takes emergency plumbing calls and we get you scheduled as fast as we can. A house with no heat in a hard freeze can also freeze pipes, so say that when you call.
Do you install furnaces or air conditioning?
No. Heating here means boilers, radiant and baseboard heat, water heaters and mini splits. If your house runs on a furnace or refrigerated air, you want a contractor who works on ducted systems. We will say so on the phone rather than send someone out.
More From Wright Flow Plumbing and Heating

Work That Pairs With Boilers and Radiant Heat

Black iron gas piping with shutoff valves branching across a basement ceiling

Gas Lines

We run new gas lines and repair old ones, on natural gas and on propane. Gas piping for ranges, water heaters, boilers, dryers, grills and fire pits.

Learn More
Wall-mounted mini split head above the seating in a living room

Mini Splits

Ductless mini split heat pumps installed and repaired, from one room to a whole house. The same system heats in winter and cools in summer, with no ductwork.

Learn More
Hand tools laid on top of a tank water heater with its water connections above

Water Heater Repair

We repair gas, electric and tankless water heaters for homes, rentals and small commercial buildings. No hot water, leaks, pilot and igniter faults, elements, thermostats and sediment.

Learn More
Why Choose Wright Flow Plumbing and Heating

Built for Plumbing and Heating in the Albuquerque Metro and the East Mountains

Plumbing and heating in one company

Drains, water heaters, gas lines and sewer work, plus boilers, radiant heat and mini splits. One call covers the water and the heat.

24 hour emergency service

Burst pipes, sewer backups and dead water heaters do not wait for Monday. Call any hour and we will get you scheduled as fast as we can.

Homes and businesses

Houses, manufactured homes, rentals and small commercial buildings. Landlords and property managers keep us on a maintenance schedule.

Based in Edgewood, working the metro

We run about 70 miles out from Edgewood, into Albuquerque, Rio Rancho, Corrales and down to Los Lunas. The East Mountains are home.

Free Estimates

Get In Touch With Wright Flow Plumbing and Heating

Tell us what is going on and where the house or building is, and we will come look at it. Call (505) 306-8285 or fill out the form and we will get back to you.

  • (505) 306-8285
  • Edgewood, NM · serving Albuquerque, Rio Rancho, Corrales, the East Mountains and about 70 miles around Edgewood
  • Free estimates · drains, water heaters, septic, sewer, gas, boilers and mini splits

Get a Free Quote

Tell us about the job. We will get right back to you.