Based in Edgewood, NM · serving the Albuquerque metro and the East Mountains
24-Hour Emergency Service · Free Estimates (505) 306-8285
Wright Flow Plumbing and Heating
Our Services

Water Heater Installation in Edgewood, NM

Water Heater Installation · Edgewood, NM

New tank water heaters sized and installed to code

Water heater installation usually starts the day the hot water quits. A tank that leaks from the shell is finished, and no part will bring it back. We size a new unit, set it in place, and connect the water and the fuel. When the tank is younger and one part has failed, water heater repair is often the better answer.

We put in tank water heaters, gas and electric, from Edgewood out through Albuquerque, Rio Rancho and Corrales. Most homes here run a 40 or 50 gallon tank in a garage, a closet or a utility room. We also fit tankless water heaters when a household wants hot water on demand. Call (505) 306-8285 for a free estimate, and we put it in writing before the work starts.

What We Handle

  • New tank water heaters in 40 and 50 gallon sizes, gas or electric
  • Replacement of a leaking or failed tank, with the old unit hauled off
  • Expansion tank installation where the house is on a closed water system
  • Temperature and pressure relief valves with a discharge line run to a safe spot
  • Venting, draft hoods and a new gas connector on gas units
  • Drip pans and drain lines where a tank sits over finished space
  • Gas water heaters set up for the elevation they are installed at
  • Water heater replacement in manufactured and mobile homes

Free Water Heater Installation Quote

Tell us about the job. We will get right back to you.

What a water heater installation includes

We start with what is there now. Tank size, fuel, venting, the shutoff and how the old unit comes out all shape the job. A 40 gallon gas tank wedged in a hall closet is different work than a garage swap. You hear the plan before we touch anything.

A new water heater is more than the tank. The temperature and pressure relief valve needs a discharge line run to a safe spot. A gas unit needs venting that draws right and a fresh connector at the gas valve. On an electric unit the wiring has to match the new heater. An electrician handles any panel work.

If the house has a pressure reducing valve at the meter, the water system is closed. Heated water expands with nowhere to go, so pressure climbs and the relief valve weeps. An expansion tank takes up that swing, and we add one where the house calls for it. The old heater leaves with us.

Does altitude change which water heater you need?

For gas units, yes. The fuel gas code rates appliance input up to 2,000 feet above sea level. Past that the rated input drops about 4 percent per 1,000 feet. A maker's instructions can set a different figure.

Edgewood sits near 6,700 feet and the Albuquerque valley floor is closer to 5,300. A gas water heater here has to be approved for that elevation. Some models need a high altitude setup from the maker. Electric units do not care how high the house sits.

Fuel matters too. Plenty of East Mountain homes burn propane rather than natural gas, and the two run at different pressures. When a new heater needs a line run or resized, that is gas line installation. We handle it on the same visit where we can.

Replacing a water heater in Albuquerque and the East Mountains

Tanks do not last forever. Federal energy guidance puts a heater past ten years on the replacement list. The signs read plainly: rust in the hot water, damp metal at the base, rumbling as it heats. A tank that splits on its own becomes an emergency plumbing job, and we take those calls day or night.

Size is the other decision. A 40 gallon tank suits one or two people with a single bathroom. A 50 gallon tank fits a household that showers back to back or runs the washer at once. We size it on bathrooms and habits, not square footage.

A swap can also need a permit and an inspection. In New Mexico that runs through the state Construction Industries Division or a local building department. Which one applies depends on where the house sits. We pull the paperwork and meet the inspector.

Tank water heater strapped to the wall with new copper water connections Top of a newly installed gas water heater with flue vent, flex connector and expansion tank

Ready to get started?

Free estimates and site visits across Albuquerque, Rio Rancho, Corrales, the East Mountains and about 70 miles around Edgewood.

(505) 306-8285
How We Work

How a Job With Wright Flow Plumbing and Heating Runs

From the first call to the final test, here is how it goes.

1

You call

Call (505) 306-8285 and tell us what is happening and where. We ask a few questions so we bring the right parts.

2

We get you on the schedule

Emergencies go first. Everything else gets a day and a window that works for you.

3

We look at the job

We find what is actually wrong and explain it in plain words. Then the estimate goes in writing before any work starts.

4

We do the work

The repair or the install, with the parts it needs. Where a permit or an inspection is required, we handle that paperwork with you.

5

We test it and clean up

We run the water or fire the unit and check it. Then we clean up and tell you how to keep it working.

FAQ

Water Heater Installation Questions, Answered

Common questions about water heater installation across Albuquerque, Rio Rancho, Corrales, the East Mountains and about 70 miles around Edgewood. If yours is not here, call and ask.

Call (505) 306-8285

How long does a water heater installation take?
A straight tank swap in an open garage is usually a few hours. It runs longer when the venting changes or the gas line needs work. A tank buried in a closet or an attic also adds time.
Should I get a 40 gallon or a 50 gallon water heater?
It comes down to how much hot water gets pulled at once. One or two people with a single bathroom are usually fine on 40 gallons. A house with two bathrooms and back to back showers is better on 50.
Do I need a permit to replace a water heater?
Often yes, and it turns on whether the house sits in a city, a village or out in the county. The work goes through the state Construction Industries Division or a local building department. We handle the permit and the inspection as part of the job.
What is an expansion tank and does my house need one?
A pressure reducing valve or a check valve at the meter makes a closed water system. Water expands as it heats, so the pressure climbs and the relief valve drips. An expansion tank absorbs that swing, and we fit one where it belongs.
How often does the anode rod need to be replaced?
The anode rod corrodes on purpose so the steel tank does not. How fast it goes depends on the water it sits in. Having it checked every few years, and swapped once it is eaten up, adds years to a tank.
What does a new water heater cost to install?
Price moves with tank size, gas or electric, and what the install needs beyond the unit. Venting changes, gas work, an expansion tank or a permit all add to it. We give a free estimate in writing before the work starts. For market ranges, see our post on water heater replacement cost in New Mexico.
More From Wright Flow Plumbing and Heating

Work That Pairs With Water Heater Installation

Wall-mounted gas tankless water heater with copper piping in a garage

Tankless Water Heaters

We install and replace tankless water heaters in houses, rentals and small commercial buildings. Sizing, the gas line, the vent and the descaling schedule are part of the job.

Learn More
Hand tools laid on top of a tank water heater with its water connections above

Water Heater Repair

We repair gas, electric and tankless water heaters for homes, rentals and small commercial buildings. No hot water, leaks, pilot and igniter faults, elements, thermostats and sediment.

Learn More
Black iron gas piping with shutoff valves branching across a basement ceiling

Gas Lines

We run new gas lines and repair old ones, on natural gas and on propane. Gas piping for ranges, water heaters, boilers, dryers, grills and fire pits.

Learn More
Why Choose Wright Flow Plumbing and Heating

Built for Plumbing and Heating in the Albuquerque Metro and the East Mountains

Plumbing and heating in one company

Drains, water heaters, gas lines and sewer work, plus boilers, radiant heat and mini splits. One call covers the water and the heat.

24 hour emergency service

Burst pipes, sewer backups and dead water heaters do not wait for Monday. Call any hour and we will get you scheduled as fast as we can.

Homes and businesses

Houses, manufactured homes, rentals and small commercial buildings. Landlords and property managers keep us on a maintenance schedule.

Based in Edgewood, working the metro

We run about 70 miles out from Edgewood, into Albuquerque, Rio Rancho, Corrales and down to Los Lunas. The East Mountains are home.

Guides and Resources

Water Heater Installation Guides

Free Estimates

Get In Touch With Wright Flow Plumbing and Heating

Tell us what is going on and where the house or building is, and we will come look at it. Call (505) 306-8285 or fill out the form and we will get back to you.

  • (505) 306-8285
  • Edgewood, NM · serving Albuquerque, Rio Rancho, Corrales, the East Mountains and about 70 miles around Edgewood
  • Free estimates · drains, water heaters, septic, sewer, gas, boilers and mini splits

Get a Free Quote

Tell us about the job. We will get right back to you.